When the heat goes out in Pueblo, CO, the clock starts running, and the diagnosis depends entirely on what kind of system is doing the failing. On a gas furnace, the most common no-heat call we run is a flame sensor coated in oxide: the burners light, the sensor cannot prove the flame, and the board shuts the gas down after the third attempt and locks out. Close behind come cracked hot surface igniters, stuck pressure switches, clogged condensate traps on high-efficiency models, and blower motors that have quietly worn out. Heat pumps fail differently: a weak defrost cycle leaves the outdoor coil buried under frost, a failed reversing valve strands the system in cooling, and a dead outdoor unit leaves the electric backup strips carrying the whole house at several times the operating cost.
Our most requested repair is Furnace Repair. That's the place to start if you need a fix today.
Warning Signs for Heating Repair
Spotting the early warning signs lets you act before the problem gets expensive. Here are the most common indicators that it's time to call a professional:
- The furnace clicking and trying to light but shutting back down
- Thick ice or frost covering the heat pump outside
- Higher heating bills with less comfort to show for them
- Cold rooms in one part of the house while others are comfortable
- Frequent on-off cycles that never bring rooms up to temperature
- No warm air at the registers even with the heat turned up
- Banging at startup caused by burners lighting late
- Strange smells from the vents, especially rotten egg or burning
Don't Wait for a Total Failure
A failing capacitor, clogged condensate drain, or dirty flame sensor rarely fixes itself and usually gets more expensive to address the longer it runs. If you notice any of these signs, call (719) 697-8654 for a prompt inspection.
